Thousands of products in stock
NEODYMIUM Power Magnetic Tape 10000 x 10 x 1.5 mm - raw
-
Daily shipping and fast delivery
-
No minimum order value
-
Personal advice
For many years the magnetic foils and tapes could only be made from ferrite material. Due to the increasing demand for even stronger foils, the neodymium magnetic foil was developed.
Neodymium-iron-boron is mostly used for the production of so-called super magnets. An enormous adhesive force can be achieved here in the smallest of spaces.
Our neodymium magnetic foils achieve a much higher adhesive force than normal magnetic foils. These foils can now be used in areas where the adhesive force achieved by the ferrite foils was not sufficient before.
These power neodymium tapes have an adhesive force of 415 g/cm²
For comparison: adhesive force of a normal magnet made of ferrite: 102 g/cm²
Advantages:
- elastic and flexible
- Can be cut to size with a craft knife or sturdy scissors
| Width: | 10,0 mm |
| Thickness: | 1,5 mm |
| Roll of: | 10 meters |
| Magnetization: | isotropic |
| Magnetization quality: | R6 |
| Temperature range: | - 40°C bis + 100°C |
| Adhesive force: | 415 g/cm² |
| Weight: | 0,800 kg / piece |
| Shore D hardness: | > 30 |
| Pole spacing: | 5 mm |
The technical data for this product can be found in our Technical specifications
Technical specifications
| Lenght: | 10 m |
|---|---|
| Width: | 10 mm |
| Adhesive force: | 415 g/cm² |
| Material: | Neodymium |
| Magnetization quality: | R6 |
| Weight: | 800 g |
The product conforms to the European RoHS Community legislation
The product conforms to the European RoHS Community legislation (2002/95/EC - RoHS - Restriction of Hazardous Substances) relating to the use and the employment of certain hazardous substances in electrical and electronic devices. This product is not subject to registration according to REACH.
Determination of the magnetic force
The adhesive force of our magnets is determined at room temperature on a polished plate made of steel S235JR (ST37) with a thickness of 10 mm by the vertical withdrawal of the magnet (1kg ~ 10 N). A different value down to -10% compared to the specified value is possible in exceptional cases. In general, the value is exceeded. Please note that for thinner, painted and not absolute plan undergrounds the adhesive force represents only one raction of the specified values.