NdFeB Deep pot magnet Ø 10 x 20 mm, brass, tolerance h6 - 4.6 kg

Deep pot magnet with built-in sandwich magnet system made of neodymium (NdFeB), brass housing and fit tolerance h6.
To distinguish the deep pot magnet from the identical SmCo systems, these magnets are colored blue on the adhesive side.
This deep pot magnet is available in 8 different dimensions, from 6 to 32 mm in diameter. This magnet can be attached by pressing, gluing or shrinking.

Dimensions / Tolerances
Diameter:	10,0 mm h6
Length:	20,0 mm +/- 0,2 mm

The deep pot magnet can be shortened on the back by a length of 10 mm without reducing the adhesive force or damaging the magnet.

Please note that if the deep pot magnet is installed directly in iron, the adhesive force will be reduced by up to 15% due to magnetic short circuits. To avoid this, a distance of 1.5 mm must be maintained between the brass housing of the deep pot magnet and the iron.
The distance to the iron must also be maintained if the deep pot magnet has been shortened by a length of 10 mm.

• The product conforms to the European RoHS Community legislation

  The product conforms to the European RoHS Community legislation (2002/95/EG - RoHS - Restriction of Hazardous Substances) relating to the use and the employment of certain hazardous substances in electrical and electronic devices.
  No subject to registration under the REACH Regulation.

• Determination of the magnetic force

  The adhesive force of our magnets is determined at room temperature on a polished plate made of steel S235JR (ST37) with a thickness of 10 mm by the vertical withdrawal of the magnet (1kg ~ 10 N). A different value down to -10% compared to the specified value is possible in exceptional cases. In general, the value is exceeded. Please note that for thinner, painted and not absolute plan undergrounds the adhesive force represents only one raction of the specified values.